Pacifica V6-3.8L VIN L (2005)
8) Remove two brake caliper guide pin bolts (Fig. 45).
9) Remove disc brake caliper from brake adapter and hang out of way using wire or a bungee cord.
Use care not to overextend brake hose when doing this.
10) Remove guide pins and boots from adapter as shown (Fig. 46).
INSTALLATION
1) Lubricate guide pins and inside boots with packet supplied with service kit, Sythesco GLK-1 lubricant or equivalent.
2) Install guide pins and boots in adapter as shown (Fig. 46). The boots have grooves built into their inner lips to fit onto pins and adapter.
CAUTION: If adhesive is missing from noise suppression gasket on rear of either inner and outer brake shoes or if gasket is damaged, replace
brake shoes.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
3) Install disc brake caliper over brake shoes on brake caliper adapter.
4) Align caliper guide pin bolt holes with guide pins, then install caliper guide pin bolts (Fig. 45). Tighten upper (closest to bleeder screw) bolt to 43
Nm (32 ft. lbs.) torque, then tighten lower bolt to 43 Nm (32 ft. lbs.) torque.
5) Install tire and wheel assembly. Tighten wheel mounting nuts to 135 Nm (100 ft. lbs.) torque.
6) Lower vehicle.
7) Pump brake pedal several times to set shoes to brake rotor.
8) Check and adjust brake fluid level as necessary.