Pacifica V6-3.8L VIN L (2005)
CAB Wiring Connector
5. Disconnect 47-way wiring connector at CAB.
6. Remove CAB.
INSTALLATION
1. Connect 47-way wiring connector at CAB.
2. Align CAB solenoids and pump/motor wiring connector with HCU valves and connector passage. Slide CAB onto HCU.
3. Install 3 screws mounting CAB to HCU. Tighten CAB mounting screws to 2 N.m (17 in. lbs.) torque.
4. Lower vehicle.
5. Connect negative battery cable to battery post.
6. Hook up DRBIII(R) to initialize CAB. Check and clear any faults.