Pacifica V6-3.8L VIN L (2005)
11. Remove the tape or plugs from the liquid line rear fitting and the receiver/drier outlet port.
12. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
13. Connect the liquid line fitting to the receiver/ drier outlet port.
14. Install the screw that secures the liquid line fitting to the receiver/drier. Tighten the screw to 11 N.m (97 in. lbs.).Connect the wire harness
connector to the A/C pressure transducer.
16. Install the drain tube to the wiper module.
17. Install the air cleaner housing and air inlet tube.
18. Reconnect the negative battery cable.
19. Evacuate the refrigerant system.
20. Charge the refrigerant system.