Pacifica V6-3.8L VIN L (2005)
7. If NOT equipped with power adjustable pedals, pull the accelerator pedal upward and push the brake pedal downward for clearance to remove the
heater core from the air distribution housing.
8. Remove the heater core by carefully pulling it straight out of the side of the air distribution housing.
Installation
1. If NOT equipped with power adjustable pedals, pull the accelerator pedal upward and push the brake pedal downward for clearance to install the
heater core into the HVAC air distribution housing.
2. Install the heater core by carefully pushing it straight into the side of the air distribution housing.
3. Install the two screws that secure the heater core to the air distribution housing. Tighten the screws to 2 Nm ( 17 in lbs ).
4. Install the heater core tubes.
5. If equipped with power adjustable pedals, install the adjustable pedal assembly.
6. Connect the power brake booster input rod to the pin on the brake pedal arm.
7. Install a new brake lamp switch.
8. Install the silencer boot around the base of the lower steering shaft on the dash panel.
9. Reconnect the negative battery cable.
10. If the heater core is being replaced, flush the cooling system.
11. Refill the engine cooling system.