Pacifica V6-3.8L VIN L (2005)
Condenser Outlet Connection
7. Remove the nut that secures the A/C liquid line to the A/C condenser.
8. Disconnect the A/C liquid line from the A/C condenser and remove and discard the O-ring seal and gasket.
9. Install plug in, or tape over the opened liquid line fitting and the condenser port.
A/C Liquid Line (Front Section)
10. Disengage the refrigerant line routing clip located on top of the right frame rail.
11. Remove the bolt that secures the front of the A/C liquid line to the receiver/drier.
12. Disconnect the front of the A/C liquid line from the receiver/drier and remove and discard the O-ring seal.
13. Install plug in, or tape over the opened liquid line fitting and the receiver/drier port.
14. Remove the front of the A/C liquid line from the engine compartment.
INSTALLATION
NOTE: The A/C liquid line is serviced in two sections. The front connects between the A/C condenser and the receiver/drier and includes the high side
service port. The rear connects between the receiver/drier and the A/C expansion valve and includes the fitting for the A/C pressure transducer.
1. Position the front of the A/C liquid line into the engine compartment.
2. Remove the tape or plugs from the liquid line fitting and the receiver/drier port.