chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Audible Warning Device|Description and Operation|Page 8262 > < Audible Warning Device|Description and Operation
Page 2
background image

Chime sounds when the engine is operating and the coolant temperature exceeds 252° F (122° C). The chime is continuous at 257° F (125° C) and will
chime for 4 minutes and stop if the temperature drops below 243° F (117° C).

LOW WASHER FLUID

Chime sounds when the washer fluid drops below a specific level.

WARNING LAMP ANNOUNCEMENT

Chime sounds to alert the driver to scan the EVIC (in the cluster) to see which EVIC warning message displayed. The door/liftgate ajar warning message
will display (without a chime) if the vehicle is running and a door or the liftgate is open. A chime will sound if the door or liftgate is still open when
vehicle speed is greater than 1 mph (1.6 km/h).

WARNING LAMP ANNOUNCEMENT

LOW FUEL LAMP

The cluster will sound a single chime, illuminate an amber lamp, and display an EVIC warning message after illuminating the indicator.

VOLT LAMP

The cluster will sound a single chime after illuminating the indicator.

OIL PRESSURE LAMP

The cluster will sound a single chime after illuminating the indicator above 450 rpm vehicle operation.

FASTEN SEAT BELT LAMP

There are two different Fasten Seat Belt Reminder announcements incorporated into the cluster's logic, a Non-enhanced announcement and an Enhanced
announcement.
When the Enhanced announcement is DISABLED:

-

The cluster will chime five times (not greater than six seconds) and illuminate the Seat Belt Lamp after turning the ignition to the run/start
position if the driver seat belt is unbuckled.

When the Enhanced announcement is ENABLED:

-

The cluster will chime continuously at a slow rate for a period of 6 seconds and illuminate the Seat Belt Lamp after turning the ignition to the
run/start position if the driver seat belt is unbuckled. After 6 seconds the chime will stop, but the Seat Belt Lamp will stay illuminated. If the
ignition is in the run position for a period greater than 60 seconds, and the driver seat belt is unbuckled, and the vehicle's speed is greater than 5
mph (8 km/h)
 in a forward gear, the Enhanced Fasten Seat Belt Reminder will activate. This will cause the Seat Belt Lamp to blink and a slow
continuous chime to sound for 5 seconds. After 5 seconds, the chime will stop, but the lamp will remain illuminated for an additional 3 seconds.
The Enhanced Seat Belt Reminder cycles for a total of 12 times (96 seconds). After the 12th time, the Seat Belt Lamp will remain on without any
chime. Buckling the driver seat belt at anytime will cancel the Fasten Seat Belt Reminder announcement.

CHECK ENGINE LAMP

The cluster will sound a single chime after illuminating the indicator.

ENGINE TEMPERATURE LAMP

The cluster will sound a single chime when the indicator first illuminates at 252° F (122° C).

TRACTION CONTROL LAMP

The cluster will sound a chime, illuminate a red priority indicator lamp, and display an EVIC warning message after illuminating the indicator if the
traction control system:

-

is active.

-

is suspended.

-

needs service.

-

is disabled by the driver.

TURN SIGNAL ON

If the BCM detects a turn signal input continuously for 1.0 mile (0.6 km) and the vehicle speed is greater than 15 mph (24 km/h), the cluster will
chime continuously, illuminate an amber message indicator lamp, and display an EVIC warning message, until the turn signal is cancelled.

Audible Warning Device|Description and Operation|Page 8262 > < Audible Warning Device|Description and Operation