Pacifica V6-3.8L VIN L (2005)
O-ring using clean power steering fluid.
7. Install pressure hose into pump fitting (Fig. 22). Thread pressure hose tube nut into pump and tighten to 31 Nm (275 inch lbs.) torque.
8. Raise and support vehicle.
9. Position pressure and return hose tubes above A/C compressor, then install routing clamp and nut securing them in place (Fig. 23). Tighten nut to
12 Nm (105 inch lbs.) torque.
10. Install drive belt splash shield.
11. Install tire and wheel assembly. Tighten wheel mounting nuts to 135 Nm (100 ft. lbs.) torque.
12. Lower vehicle.
13. Install negative (-) battery cable on negative battery post.
14. Fill and bleed power steering system using Power Steering Pump Initial Operation Procedure.
15. Inspect for leaks.