Pacifica V6-3.8L VIN L (2005)
i.
Disconnect the fuel line, EVAP line, and vapor recirculation tube located at the right front corner of the fuel tank (Figure 4).
j.
For vehicles with all wheel drive, place alignment marks on the driveshaft where it attaches to the PTU and the rear axle.
k.
For vehicles with all wheel drive, remove the front muffler heat shield.
l.
For vehicles with all wheel drive, support driveshaft using jack stands.
m.
For vehicles with all wheel drive, disconnect the rear end of the driveshaft.
n.
For vehicles with all wheel drive, remove the center and rear driveshaft support/bearing bolts.
o.
For vehicles with all wheel drive, disconnect the front end of the driveshaft.
p.
For vehicles with all wheel drive, with the help of an assistant, lower the driveshaft assembly and set it aside.
q.
Remove the left rear tire and wheel well plastic splash shield.
r.
Remove the fuel filler tube from the rubber hose on the fuel tank.
s.
Support the fuel tank with a transmission jack.
t.
Remove the two fuel tank straps.
u.
Lower the fuel tank.
4.
Place the fuel tank on the floor.