chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

System Description|Page 338 > < System Description|Page 336
Page 10
background image

an additional 3 seconds. The Enhanced Seat Belt Reminder cycles for a total of 12 times (96 seconds). After the 12th time, the Seat Belt Lamp
will remain on without any chime. Buckling the driver seat belt at anytime will cancel the Fasten Seat Belt Reminder announcement.

Exterior Lights On:

Chime sounds if the ignition is in the lock position, the driver's door is ajar, and the headlight switch is in any position other than auto or off. The chime
will continue to sound until anyone of the above conditions change or the battery protection time of 3 minutes expires.

Key-In Ignition:

Chime sounds if the key is in the ignition, the ignition is in the lock position, and the driver's door is ajar. The chime will continue to sound until anyone
of the above conditions change or the battery protection time of 15 minutes expires.

Key-In Accessory

Chime sounds if the key is in the accessory position and the drivers' door is open. The chime will continue to sound until anyone of the above conditions
change or the battery protection time of 15 minutes expires.

Turn Signal On:

If the BCM detects a turn signal input continuously for 1.0 mile (0.6 km) and the vehicle speed is greater than 15 mph (24 km/h), the cluster will
chime continuously, illuminate an amber message indicator lamp, and display an EVIC warning message, until the turn signal is cancelled.

Low Oil Pressure:

Chime sounds when the engine is operating and the oil pressure drops below 4psi/27.5kPa.

Engine Temperature Critical:

Chime sounds when the engine is operating and the coolant temperature exceeds 252° F(122° C). The chime is continuous at 257° F(125° C) and will
chime for 4 minutes and stop if the temperature drops below 243° F(117° C).

Low Washer Fluid:

Chime sounds when the washer fluid drops below a specific level.

Door Ajar

Chime sounds when the vehicle is moving (above 1 mph /1.61 kph) and any door is open

WARNING LAMP ANNOUNCEMENT

Low Fuel Lamp:

The cluster will sound a single chime and display an EVIC warning message after illuminating the indicator.

Volt Lamp:

The cluster will sound a single chime after illuminating the indicator.

Oil Pressure Lamp:

The cluster will sound a single chime after illuminating the indicator above 450-rpm.

Fasten Seat Belt Lamp:

There are two different Fasten Seat Belt Reminder announcements incorporated into the MIC's logic, a Non-enhanced announcement and an Enhanced
announcement.

When the Enhanced announcement is DISABLED, the Fasten Seat Belt Reminder operates as follows:

-

The BCM will request the MIC to chime five times and illuminate the Seat Belt Lamp after turning the ignition to the run/start position if the
driver seat belt is unbuckled.

When the Enhanced announcement is ENABLED, the Fasten Seat Belt Reminder operates as follows:

-

The BCM will request the MIC to chime continuously at a slow rate for a period of 6 seconds and illuminate the Seat Belt Lamp after turning the
ignition to the run/start position if the driver seat belt is unbuckled. After 6 seconds the chime will stop, but the Seat Belt Lamp will stay

System Description|Page 338 > < System Description|Page 336