chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Heated Mirror Switch > < Door Lock Cylinder Switch|Description and Operation|Page 558
Page 1
background image

Door Lock Cylinder Switch: Service and Repair

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Remove the door trim panel.
3. Peel back the water deflector to expose switch.
4. Close the door window.
5. Disconnect the door cylinder lock switch wire connector from the door harness, and wiring clip from the security shield.
6. Remove the switch from the key cylinder in the door handle and remove from vehicle.

INSTALLATION

1. Install the switch on the key cylinder in the door handle. Ensure that switch is in 12'O clock position.
2. Route wire down through link rods.
3. Install three clips to security shield.
4. Connect wire harness connector.
5. Install the door trim panel.
6. Connect the battery negative cable.
7. Verify system operation.

Heated Mirror Switch > < Door Lock Cylinder Switch|Description and Operation|Page 558