Pacifica V6-3.8L VIN L (2005)
8. Attach wheel speed sensor routing bracket to strut assembly (Fig. 3). Tighten screw to 13 Nm (115 inch lbs.) torque.
9. Clip wheel speed sensor connector and routing clip to frame rail outer reinforcement (Fig. 2).
10. Connect vehicle wiring harness to wheel speed sensor connector (Fig. 2).
11. Install brake rotor, then install disc brake caliper and adapter assembly.
12. Verify that wheel speed sensor is not routed improperly allowing cable to come in contact with brake rotor or other moving parts.
13. Install washer and hub nut on end of halfshaft stub shaft (Fig. 1). With aid of a helper applying brakes to keep front hub from turning, tighten hub
nut to 244 Nm (180 ft. lbs.) torque.
14. Install spring washer and hub nut lock over hub nut and stub shaft. Install a NEW cotter pin securing nut lock in place and tightly wrap cotter pin
prongs around nut lock.
15. Install tire and wheel assembly. Tighten wheel mounting nuts to a torque of 135 Nm (100 ft. lbs.).
16. Lower vehicle.
17. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
18. Check and adjust brake fluid level as necessary.
19. Perform wheel alignment.