Pacifica V6-3.8L VIN L (2005)
34. Remove nut and bolt fastening compression link to crossmember (Fig. 89).
35. Lift compression link out of mounted position on crossmember and move it inboard.
Fig. 90
36. Assemble tools over bushing as shown (remember crossmember is upside-down) (Fig. 90). Ensure Remover lies between voids on bushing to
better contact bushing can.
37. Tighten Press screw-drive, pressing bushing out of crossmember.
INSTALLATION
CAUTION: It is very important that bushing be installed in same position as original to maintain vehicle ride quality and bushing longevity.
That is why bushing, once installed, needs closely match reference marks applied upon removal of original bushing.
1. Position bushing over crossmember bushing bore aligning bushing can flange with reference marks applied during removal.