Pacifica V6-3.8L VIN L (2005)
Fig. 86
13. Disconnect vehicle wiring harness from each rear wheel speed sensor connector (Fig. 86).
14. Unclip each rear wheel speed sensor connector from spare tire mounting support (Fig. 86).
15. If equipped with AWD:
a. Reference mark propeller shaft-to-rear driveline module input flange connection.
b. Remove three propeller shaft-to-rear driveline module mounting bolts. Do not attempt removal of shaft from module at this time due to
alignment pin interference. Removal happens as crossmember is lowered in a later step.
Fig. 93
16. Carefully mark location of rear crossmember on body at all four mount (bushing) locations using a marker or crayon (Fig. 93). Do not use a
scratch awl to mark location.