Pacifica V6-3.8L VIN L (2005)
Rear Knuckle Alignment Link: Service and Repair
Spring Link
SPRING LINK
REMOVAL
1. Raise and support vehicle.
2. Access and remove rear spring.
3. Remove spring link-to-knuckle nut and bolt (Fig. 20).
CAUTION: It is important to use Guide, Special Tool 905OA-2, when tapping sleeve to help keep Tap, Special Tool 905OA-1, straight during
use or damage to Tap may occur.
4. Place Guide 905OA-2 against sleeve in knuckle as shown (Fig. 21).
5. Insert Tap 905OA-1, on an appropriate handle, through Guide and into sleeve (Fig. 21). Cut threads approximately halfway through bushing (or
about six complete threads). It is important to back Tap out often and clean out burrs that can build up inside Guide. Keep Tap well lubricated to
avoid damaging it.
