chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Front Wheel Stud Replacement|Page 5719 > < Front Wheel Stud Replacement|Page 5717
Page 2
background image

7. Install Remover, Special Tool C-4150A, on hub and bearing flange and wheel stud (Fig. 35).
8. Tighten Remover forcing screw, pushing wheel stud out of hub and bearing flange. Remove tool.
9. Remove stud from rear of hub flange. It may be necessary to rock hub flange back and forth to ease stud removal.

INSTALLATION 

1. Install replacement wheel stud into flange of hub and bearing from rear. Install a stack of washers (approximately 5, depending on thickness) over

stud, then install a standard wheel mounting (lug) nut on stud with flat side of nut against washers (Fig. 36).

2. Tighten wheel mounting nut, pulling wheel stud into flange of hub and bearing. Once head of stud is fully seated against rear of hub flange,

remove nut and washers from wheel stud.

3. Install parking brake shoe adjuster between upper and lower parking brake shoes. Position end of adjuster with star wheel upward (Fig. 34). Once

in place, slide upper shoe downward against adjuster mounting slot, taking up any slack between two pieces.

4. Using appropriate tools, install spring at adjuster (Fig. 34).

NOTE:  When measuring brake drum diameter, diameter should be measured in center of shoe contact surface area.

5. Using Brake Shoe Gauge, Special Tool C-3919, or equivalent, measure inside diameter of parking brake drum portion of rotor (Fig. 37).
6. Place Gauge over parking brake shoes at widest point (Fig. 38).

Front Wheel Stud Replacement|Page 5719 > < Front Wheel Stud Replacement|Page 5717