Pacifica V6-3.8L VIN L (2005)
7. Place crimping tool C-4975-A over bridge of clamp (Fig. 20).
8. Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face (Fig. 21).
CAUTION: Seal boot must not be dimpled, stretched or out of shape in any way. If seal boot is NOT shaped correctly, equalize pressure in seal
and shape it by hand.
9. Position sealing boot into the tripod housing retaining groove. Install seal boot retaining clamp evenly on sealing boot.
10. Position trilobal boot to interface with the tripod housing. The lobes of the boot must be properly aligned with the recess's of the tripod housing.
CAUTION: The following positioning procedure determines the correct air pressure inside the inner CV joint assembly prior to clamping the
sealing boot to inner CV joint housing. If this procedure is not done prior to clamping sealing boot to CV joint housing sealing boot durability can
be adversely affected.
CAUTION: When venting the inner CV joint assembly, use care so that the inner CV sealing boot does not get punctured, or in any other way
damaged. If sealing boot is punctured, or damaged in any way while being vented, the sealing boot can not be used.