Pacifica V6-3.8L VIN L (2005)
4. Remove outer C/V joint from interconnecting shaft using the following procedure: Support interconnecting shaft in a vise equipped with protective
caps on jaws of vise to prevent damage to interconnecting shaft. Then, using a soft-faced hammer, sharply hit the end of the C/V joint housing to
dislodge housing from internal circlip on interconnecting shaft (Fig. 27). Then slide outer C/V joint off end of interconnecting shaft, joint may
have to be tapped off shaft using a soft-faced hammer.
5. Remove large circlip (Fig. 28) from the interconnecting shaft before attempting to remove outer C/V joint sealing boot.
6. Slide sealing boot off interconnecting shaft.
7. Thoroughly clean and inspect outer C/V joint assembly and interconnecting joint for any signs of excessive wear. If any parts show signs of
excessive wear, the halfshaft assembly will require replacement. Component parts of these halfshaft assemblies are not serviceable.
INSTALLATION