Pacifica V6-3.8L VIN L (2005)
Power Window Motor: Service and Repair
NOTE: Secure window in the UP position before removing motor.
FRONT DOOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the front door trim panel.
3. Remove the front door speaker.
4. Remove the watershield.
5. Disconnect electrical harness wire connector from the motor.
6. Remove mounting fasteners and motor.
INSTALLATION
1. Install motor and mounting fasteners to regulator.
2. Connect electrical harness connector.
3. Install front door trim panel.
4. Connect battery negative cable.
REAR DOOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear door trim panel.
3. Remove the rear door speaker.
4. Remove the watershield.
5. Disconnect electrical harness wire connector from the motor.
6. Loosen window regulator mounting fasteners (do not remove).
7. Remove mounting fasteners and motor.
INSTALLATION
1. Install motor and mounting fasteners to regulator.
2. Install window regulator.
3. Connect electrical harness connector.
4. Install rear door trim panel.
5. Connect battery negative cable.