Prowler V6-3.5L VIN G (2002)
8. Remove the timing belt tensioner (Fig. 144) and remove timing belt.
9. When tensioner is removed from the engine it is necessary to compress the plunger into the tensioner body.
CAUTION: Compress the tensioner slowly, as damage to tensioner could result.
10. Place the tensioner into a vise and SLOWLY compress the plunger (Fig. 145). Total bleed down of tensioner should take about 5 minutes.
CAUTION: Index the tensioner in the vise the same way it is installed on the engine. This is to ensure proper pin orientation when tensioner is
installed on the engine.
11. When plunger is compressed into the tensioner body install a pin through the body and plunger to retain plunger in place until tensioner is
installed.
NOTE: When timing belt tensioner is removed from engine, always store in the vertical (plunger facing upward) position.
INSPECTION - TIMING BELT - IN VEHICLE
1. Remove the accessory drive belts (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL).
2. Remove front timing belt covers (Refer to 9 - ENGINE/VALVE TIMING/TIMING BELT/CHAIN COVER(S) - REMOVAL).