PT Cruiser L4-2.4L (2008)
Keyless Entry Module: Service and Repair
Sentry Key Remote Entry Module - Installation
INSTALLATION
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order See: Powertrain Management/Computers and
Control Systems/Engine Control Module/Testing and Inspection/SKREEM Programming.
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Replace all ignition keys and program them to the new SKREEM/WCM.
1. Position the SKREEM/WCM (3) on the ignition lock housing and install the retaining screw (2).
2. Connect the SKREEM/WCM electrical connector (4).
3. Install the right multi-function switch See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper Switch/Service and
Repair/Installation.
4. Install the upper and lower steering column shrouds See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and
Repair/Shroud - Upper/Installation and See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and
Repair/Shroud - Lower/Installation.
NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a
diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the
vehicle can be operated See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming
and Relearning.
5. Connect the battery negative cable.