PT Cruiser L4-2.4L (2008)
Power Mirror Switch: Service and Repair
Installation
INSTALLATION
1. Place the mirror switch in cover opening and firmly snap into place.
2. Connect the power mirror switch wiring connector.
3. Place the left end cover in position and snap into place. Make sure that it is underneath the A-pillar trim and top cover.
4. Install two screws to the left instrument panel end cover.
5. Place left lower instrument panel bezel in position and make sure the orientation of the hinge is correct and snap bezel hinge into place
6. Roll bezel upward and snap into place.
7. Connect the battery negative cable.
