PT Cruiser L4-2.4L (2008)
-
The sunroof switch is not held in the CLOSE position.
-
The ignition or battery power is lost.
-
The glass panel has not reached its closed position.
NOTE: if the initialization procedure is not carried out completely, it must be started over.
1. Turn the ignition key to the "RUN" position.
2. Move the sunroof to the full open position.
3. Continuously press the "OPEN" button on the sunroof switch.
4. The sunroof will begin to move past the normal "OPEN" position to the hard stop position. It will then reverse to the normal "OPEN" position
also known as the soft stop. Once the sunroof has reversed to the soft stop , immediately (within 5 seconds of stopping travel) release the "OPEN"
button and continuously press it again.
5. After a delay of three seconds the sunroof will begin moving to the "VENT" and then "CLOSED" position. When the roof reaches the fully
"CLOSED" position and stops the "OPEN" button can be released.
The initialization procedure is now complete. Operate the sunroof in all directions to verify proper operation.
