PT Cruiser L4-2.4L (2008)
Seat Track: Service and Repair
Track - Power Seat
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver front seat, See: Service and Repair/Seat - Removal.
3. Remove seat cushion side shields.
4. Remove bolts attaching seat frame to cushion pan.
5. Disconnect wire harness fasteners from cushion pan.
6. Remove seat back.
7. Remove seat cushion tension springs.
8. Remove power seat track nuts.
9. Remove power seat track from riser.
10. Remove any parts that need to be transferred to the new seat track assembly.
Installation
INSTALLATION
1. Install any parts that need to be transferred from the old seat track assembly.
2. Place power seat track in position on the seat frame ensuring motor is installed correctly into seat risers.
3. Install power seat track to seat riser nuts.
4. Install seat springs.
5. Connect wire harness fasteners to the cushion pan.
6. Install bolts attaching power seat track to cushion pan.
7. Install seat back. Tighten recliner bolts to 12 Nm (9 ft. lbs.) torque. Tighten pivot bolts to 40 Nm (30 ft. lbs.) torque.
8. Install cushion side shields.
9. Install seat in vehicle, See: Seat Back/Service and Repair/Seat Back - Removal
10. Connect the battery negative cable.
11. Verify normal operation of the power seat assembly.