PT Cruiser L4-2.4L (2008)
6. Remove the vehicle wiring harness connector (2) from brake fluid level switch in master cylinder brake fluid reservoir (1).
7. Disconnect the two front brake tubes (1, 3) from the master cylinder, and the two rear brake tubes (4, 5) from the proportioning valves (2). Install
plugs at all of the open brake tube outlets on the master cylinder.
8. If equipped with a manual transaxle, remove the hose clamp (2) and slide the clutch actuator hose (3) off the reservoir port.
9. Clean the area around where the master cylinder attaches to the power brake booster using a suitable brake cleaner such as Mopar(R) Brake Parts
Cleaner or equivalent.
