PT Cruiser L4-2.4L (2008)
11. Disconnect the ABM harness connector from the antilock brake module (ABM). To do so:
a. Depress the tabs on each side of the connector cover, then
b. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be
pulled straight outward off the ABM (1).
12. Raise and support the vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
13. Remove the two rear mounting screws (4) attaching the ICU mounting bracket (3) to the body (1).
14. Lower the vehicle.
15. Remove the front mounting screw (2) attaching the ICU mounting bracket (3) to the body (1).
16. Lift the ICU and mounting bracket from the vehicle.
17. To separate the ABM from the HCU, See: Overhaul/Disassembly.
Integrated Control Unit (ICU) - Installation
INSTALLATION
