PT Cruiser L4-2.4L (2008)
7. Cycle the parking brake lever once to position the parking brake cables, then fully apply the parking brake.
8. Raise the vehicle to a point where the rear wheels just clear the floor. Check the rear wheels of the vehicle. They should not rotate with the lever in
its full upright (applied) position.
9. Return the parking brake lever to its released position.
10. Check the rear wheels of the vehicle. They should rotate freely without excessive dragging with the lever in its released position. If excessive drag
is present, adjust the brake shoes and repeat above parking brake test.
11. Apply the parking brake.
12. Lower the vehicle.
13. Install the center console and rear window switch panel. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center
Console - Installation
14. Remove the blocks from the tires and wheels.
15. Connect the battery negative cable (1) to its post on the battery (4).
