PT Cruiser L4-2.4L (2008)
3. Clean crankshaft and target ring with MOPAR(R) Brake Parts cleaner and dry with compressed air to ensure that the crankshaft mating surface and
target ring mounting holes are free from oil and lock patch debris.
NOTE: Always use NEW mounting screws whether installing original or new target ring.
4. Install NEW mounting screws finger tight starting with the #1 location. Make sure engagement occurs with the shoulder of the screws and
mounting hole before starting all other screws.
5. Torque all mounting screws with T30 torx bit to 13 Nm (110 in-lbs) following the torque sequence.
6. Oil the bearings and journals. Install crankshaft in engine block.
CAUTION: Use only the specified anaerobic sealer on the bed plate or damage may occur to the engine.
7. Apply a 1.5 to 2.0 mm (0.059 to 0.078 in.) bead of Mopar(R) Bed Plate Sealant to bed plate as shown.
8. Install lower main bearings into main bearing cap/bed plate. Make certain the bearing tabs are seated into the bed plate slots. Install the main
bearing/bed plate into engine block.
