PT Cruiser L4-2.4L (2008)
1. Slide a hose clamp onto the power steering fluid reservoir end of the return hose far enough to clear the molded fitting on the reservoir once the
hose is installed.
2. Install the return hose into the engine compartment from the top. First, place the reservoir end of the return hose (4) onto the molded fitting on the
power steering fluid reservoir (1), then route the rest of the hose down the rear of the engine.
3. Expand the hose clamp and slide it onto the fluid reservoir fitting. Secure the clamp once it is past the bead formed into the fluid reservoir fitting.
4. Raise and support the vehicle.
CAUTION: The power steering fluid hoses must remain away from the exhaust system, vehicle components, and unfriendly surfaces that
can cause possible damage to the power steering hoses.
5. Using a lint free towel, wipe clean the open power steering hose end and the power steering fluid cooler tube.
6. Install a hose clamp onto the end of the hose far enough to clear the fitting on the steering gear or cooler once the hose is installed.
7. LHD - Slide the return hose (3) onto the end of the cooler (2) tube. Install the hose clamp past the bead formed into the end of the cooler tube and
secure in place.
