PT Cruiser L4-2.4L (2008)
Whenever you pull a trailer, regardless of the trailer size, stop lights and turn signals on the trailer are required for motoring safety.
The Trailer Tow Package may include a four- or seven-pin wiring harness. Use a factory approved trailer harness and connector.
NOTE: Do not cut or splice wiring into the vehicles wiring harness.
The electrical connections are all complete to the vehicle but you must mate the harness to a trailer connector. Refer to the following illustrations.
Towing Tips
Before setting out on a trip, practice turning, stopping and backing the trailer in an area away from heavy traffic.
Towing Tips - Automatic Transmission
The OVERDRIVE/DRIVE range can be selected when towing. However, if frequent shifting occurs while in this range, the [3] range should be
selected.
NOTE: Using the [3] range while operating the vehicle under heavy operating conditions will improve performance and extend transmission life by
reducing excessive shifting and heat build up. This action will also provide better engine braking.
The automatic transmission fluid and filter should be changed if you REGULARLY tow a trailer for more than 45 minutes of continuous operation. See
the "Maintenance Schedule" in Section 8 for transmission fluid change intervals.
NOTE: Check the automatic transmission fluid level before towing.
Towing Tips - Electronic Speed Control (If Equipped)
-
Don't use in hilly terrain or with heavy loads.
-
When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cruising speed.
-
Use speed control in flat terrain and with light loads to maximize fuel efficiency.
Towing Tips - Cooling System
To reduce potential for engine and transmission overheating, take the following actions:
-
City Driving - When stopped for short periods of time, put transmission in neutral and increase engine idle speed.
-
Highway Driving - Reduce speed.
-
Air Conditioning - Turn off temporarily.
-
Refer to Cooling System Operating information in the Maintenance section for more information.
