PT Cruiser L4-2.4L (2008)
8. Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the flash
process is complete, proceed to Step # 9.
9. Disconnect the DRBIII(R) from TechCONNECT.
10. Open the hood and install a battery charger. Using a voltmeter, verify that the charging rate provides 13.2 - 13.5 volts. Set the battery charger to
continuous charge. Do not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is
complete.
NOTE:
Do not allow the charging voltage to climb above 13.5 volts during the flash process.
11. Connect the DRBIII(R) to the vehicle.
12. Download the flash file from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a. "Vehicle Flash".
b. Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to the next step.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules within the vehicle, if so equipped. Some DTC's may cause the MIL to
illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning the vehicle to the customer. Erase
any DTC's in the PCM only after all other modules have had their DTC's erased.
13. Reset the "Pinion Factor as necessary.
14. Perform the transmission Quick Learn Procedure as necessary.
NOTE:
The following step is required by law.
15. Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label 0.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
