PT Cruiser L4-2.4L (2008)
Power Steering Pressure Switch: Service and Repair
Removal
REMOVAL
NOTE: Before proceeding, See: Steering and Suspension/Steering/Service Precautions.
1. Raise and support the vehicle. See: Maintenance/Vehicle Lifting/Service and Repair.
2. Locate the power steering fluid pressure switch (3) on the back side of the power steering gear (2).
3. Release the locking tab on the wiring harness connector (1) at the pressure switch, then disconnect the wiring harness connector.
NOTE: When removing and installing the power steering pressure switch, use a deep well socket. The deep well socket will prevent
damage to the plastic electrical connector area of the power steering fluid pressure switch.
4. Unscrew and remove the power steering fluid pressure switch from the power steering gear.