PT Cruiser L4-2.4L (2008)
6. Disengage seat back trim cover J-strap from the upper, lower and airbag side of seat back.
7. Disconnect the seat airbag electrical connector (3) and slide the yellow locking tab down to unlock. Then with two fingers, push two side retaining
tabs in and pull connector straight from module (2).
8. Remove the seat airbag retaining nuts and bracket.
9. Grasp the upper airbag side of the seat back trim cover and pull trim cover and cushion over top of seat back frame. This will allow room to
remove seat airbag without damaging trim cover or cushion.
10. Working between seat back trim cover/cushion and frame carefully unhook seat airbag studs from nylon sleeve (1) and slide airbag out of sleeve.
Be careful not to tear nylon sleeve as this will affect function of airbag system.
CAUTION: Be certain not to tear the seat airbag nylon sleeve during removal.
Installation
INSTALLATION
DEPLOYED SEAT AIRBAG
WARNING: Do not replace a deployed seat airbag. If the seat airbag has been deployed, the entire seat back and all damaged parts must be
replaced.
If the seat airbag was deployed, the entire seat back must be replaced See: Body and Frame/Seats/Seat Back/Service and Repair/Seat Back - Installation.
NONDEPLOYED SEAT AIRBAG
WARNING: Only replace a nondeployed seat airbag if faulty or defective.
