PT Cruiser L4-2.4L (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Occupant Restraint Controller (ORC) Module - Removal
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
3. Remove the center console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console - Removal.
4. Remove Occupant Restraint Controller (ORC) mounting screws (1).
5. Disconnect the two ORC 32-way connectors (3, referred to as C1 and C2 in the diagnostic information and wiring).
6. Remove ORC (2) from vehicle.
