PT Cruiser L4-2.4L (2008)
SIDE MOUNTED
1. Disconnect and isolate the battery negative cable remote terminal.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
2. Remove the lower B-pillar trim from the appropriate side of the vehicle See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Pillar Trim/B-Pillar Trim.
3. Disconnect the SAS electrical connector (3).
4. Remove the SAS retaining screws (2) and remove the sensor (1) from the vehicle.
Installation
INSTALLATION
FRONT MOUNTED
LEFT FRONT SATELLITE ACCELERATION SENSOR
1. Position SAS (1) on side radiator support and install the two retaining screws (2). Tighten the screws to 10.5 Nm (92 in. lbs.).
2. Connect the SAS electrical connector (3).
3. Install the front lower grille See: Body and Frame/Grille/Service and Repair/Grille - Installation.
WARNING: Do not connect the battery negative cable. Serious or fatal injury may result if the system test is not performed first.
RIGHT FRONT SATELLITE ACCELERATION SENSOR
