PT Cruiser L4-2.4L (2008)
4. Insert the fork (1) into weight sensor and seat the support yoke (2) firmly against the weight sensor cage. Tighten nut to 45 Nm (33 ft. lbs.). Repeat
for all four sensors.
5. Connect each weight sensor electrical connector.
6. Reinstall the passenger front seat See: Body and Frame/Seats/Service and Repair/Seat - Installation.
WARNING: Do not connect the battery negative cable See: Restraint Systems/Air Bag Systems/Testing and Inspection. Serious or fatal
injury may result if the system test is not performed first.
WARNING: Following successful completion of the Airbag System verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool and the Occupant Classification Seat Weight special tool 9077. Refer to the appropriate diagnostic
information.
