PT Cruiser L4-2.4L (2008)
11. If ignition switch transfer is required, remove the ignition switch (2) mounting screw (1).
12. If ignition switch transfer is required, pull the switch (1) straight out and off the retaining tabs (2) located on the lock cylinder housing.
Installation
INSTALLATION
NOTE: Install the ignition switch prior to lock housing installation on the column to avoid complications due to interference with the tilt lever.
1. Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
CAUTION: Use care when installing the ignition switch on the lock cylinder housing to avoid damaging the key-in plunger (3).
2. Align the ignition switch with the key-in plunger (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the
