PT Cruiser L4-2.4L (2008)
cylinder housing (3).
10. Insert an appropriate tool into the slot (1) formed into the lock cylinder housing. Depress the key cylinder retaining tab.
11. Pull key cylinder (3) and key (2) straight out of the lock cylinder housing as one unit.
Installation
INSTALLATION
1. Place actuator in the lock cylinder housing to the RUN position (if not already there).
2. Insert key into key cylinder and turn key cylinder to the RUN position.
3. Align the retaining tab on the key cylinder with the slot in the top of the lock cylinder housing.
4. Slide key cylinder into the lock cylinder housing until key cylinder retaining tab locks the cylinder into place.
5. Rotate key back and forth (OFF to START), then remove and reinstall it, making sure key cylinder and lock cylinder housing operate properly.
6. Slide the ring of SKREEM/WCM (2) over lock cylinder housing (3) and engage the retainer fingers in the recesses formed on the lock cylinder
housing.
7. Install screw (1) fastening the SKREEM/WCM (2) to lock cylinder housing (3). Tighten screw to 2.5 Nm (22 in. lbs.).
