PT Cruiser L4-2.4L (2008)
8. RHD - Slide the return hose (1) onto the end of the cooler (4) tube. Install the hose clamp past the bead formed into the end of the cooler tube and
secure in place.
9. Lower the vehicle.
10. Fill and bleed the power steering system. See: Power Steering Bleeding/Service and Repair
11. Check for leaks at all hose connections.
Supply Hose - 2.4L
2.4L
1. Slide hose clamps onto both ends of the power steering fluid supply hose far enough to clear the fittings on the reservoir and pump once the hose is
installed.
2. Install the power steering supply hose into the engine compartment. First, route the pump end of the hose down to the pump supply fitting, then
place the reservoir end of the supply hose (3) onto the fitting of the power steering fluid reservoir (1).
3. Expand the hose clamp at the fluid reservoir and slide it over the hose and fitting. Secure the clamp once it is past the bead formed into the fluid
reservoir fitting.
