PT Cruiser L4-2.4L (2008)
7. Remove the fastener (5) securing the drive belt splash shield (3) to the front suspension crossmember (6).
8. Remove the fasteners (4) securing the splash shield (3) to the body (2).
9. Remove the drive belt splash shield (3).
10. Remove the mounting nuts (1, 3), then the pencil strut (2) from the right front corner of the crossmember and body of the vehicle. Remove the
washer (4) behind the strut from the torque strut (5) bolt.
11. Remove the bolt (5) mounting the engine torque strut (2) to the crossmember (1).
NOTE: Before removing the front suspension crossmember from the vehicle, the location of the crossmember must be scribed on the body
of the vehicle. Do this so the crossmember can be relocated, upon reinstallation, against the body of vehicle in the same location as before
removal. If the front suspension crossmember is not reinstalled in exactly the same location as before removal, the preset front wheel
alignment settings (caster and camber) will be lost.
12. Using an appropriate marker (2), draw a line (1) as necessary marking the location of the front suspension crossmember (3) where mounted against
