PT Cruiser L4-2.4L (2008)
Axle Beam: Service and Repair
Removal
Rear Disc Brake Vehicles
REAR DISC BRAKE VEHICLES
WARNING: The automatic adjusting feature of the parking brake lever contains a clockspring loaded to approximately 19 pounds. Do not
release the automatic adjuster lockout device unless the rear parking brake cables and equalizer are connected to the lever output cable. Keep
hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could lead to serious injury.
WARNING: When repairs to the parking brake lever or cables are required, the automatic adjuster must be loaded and locked out to avoid
possible injury. The lever adjustment mechanism can be loaded and locked out as outlined in this procedure.
WARNING: The airbag system is a complex electromechanical unit. Before attempting to service any component near the Occupant Restraint
Controller (ORC), first disconnect and isolate the battery negative cable. Allow the system capacitor to discharge for two (2) minutes. Failure
to do this could result in accidental airbag deployment and possible personal injury.
NOTE: Before proceeding, See: Service Precautions/Rear Suspension.
1. If applicable to access battery, unclip the air cleaner cover (two clips) and move the cover aside.
2. Disconnect and isolate the battery negative cable (1) from its post on the battery (4).
3. Block the tire and wheels so the vehicle does not move once the vehicle parking brake lever is released.
