PT Cruiser L4-2.4L (2008)
9. Install the cable core (1) end to the plastic cam of the shifter mechanism (2). Snap the shifter/ignition interlock cable end fitting into the groove in
the gearshift mechanism.
10. Adjust interlock cable/system as follows: If interlock cable is being replaced, it will come with an adjustment pin. Remove the pin from the
cable and allow the cable to "self-adjust". Lock cable adjustment by pressing down on the adjuster lock until bottomed at the cable housing. If
interlock cable is being re-used, no pin will be provided. Pry up on cable adjuster lock to release and allow cable to "self-adjust". Lock cable
adjustment by pressing down on the adjuster lock until bottomed at the cable housing.
11. Connect battery negative cable and verify interlock system operation as follows:
12. Install shifter bezel (1).
