PT Cruiser L4-2.4L Turbo (2009)
Air Door Actuator / Motor: Service and Repair
Recirculation Door Actuator - Installation
INSTALLATION
1. Position the recirculation door actuator (1) into the vehicle.
2. Install the recirculation door actuator onto the left side of the HVAC air inlet housing (2). If necessary, rotate the actuator slightly to align the pin
on the actuator lever (4) with the groove in the recirculation door lever (3).
3. Position the right floor distribution duct (1) out of the way and install the screws (5) that secure the recirculation door actuator (2) to the air inlet
housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
4. Connect the wire harness connector (4) to the recirculation door actuator.