PT Cruiser L4-2.4L Turbo (2009)
Air Duct: Service and Repair
Defroster Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Remove the instrument panel assembly from the vehicle and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel - Removal.
2. Disconnect the right demister duct (1) and the left demister duct (3) from the defroster duct (4).
3. Remove the four screws (2) that secure the defroster duct to the instrument panel and remove the duct.
Defroster Duct - Installation
INSTALLATION
1. Position the defroster duct (4) to the back of the instrument panel.
2. Install the four screws (2) that secure the defroster duct to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the right demister duct (1) and the left demister duct (3) to the defroster duct.
4. Install the instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel - Installation.
Floor Distribution Duct - Removal