PT Cruiser L4-2.4L Turbo (2009)
1. Position the air distribution duct (2) into the back of the instrument panel cover (3).
2. Install the six screws (1) that secure the air distribution duct to the instrument panel cover. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the instrument panel support into the instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Instrument Panel Support - Installation.
4. Install the instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel - Installation.
CENTER DUCT
1. Position the center duct (2) into the opening in the instrument panel (1). Rotate and tilt the duct as necessary.
2. Engage the center duct to the air distribution duct (3). Make sure the retaining tabs are fully engaged.
3. Install the instrument panel center bezel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Installation.
Instrument Panel Demister Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.