PT Cruiser L4-2.4L Turbo (2009)
Control Assembly: Service and Repair
A/C and Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Disengage the center bezel (7) from the instrument panel to gain access to the back of the A/C-heater control See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
3. Disconnect the wiring connector for the clock, power window switches and the accessory switches, as equipped.
NOTE: To aid in reinstallation, note the installed positions of the control cables prior to removal.
4. Using a small screwdriver or similar tool, disengage the retaining clips that secure the control cables (1 and 9) to the back of the A/C-heater
control (8) and disconnect the cables from the mode control lever (2) and the temperature control lever (5).
5. Disconnect the wire harness connectors (3 and 4) from the rear of the A/C-heater control and place the center bezel on a work bench.
6. Remove the four screws (6) that secure the A/C-heater control to the back of the center bezel and remove the control.