PT Cruiser L4-2.4L Turbo (2009)
14. Install the air distribution housing (2) onto the HVAC housing (1) See: Removal and Replacement/HVAC Housing - Installation.
15. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.
Air Inlet Housing
HOUSING-AIR INLET
NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar.
1. Align the pivot shafts of the recirculation-air door (3) to the pivot shaft holes in the air inlet housing (5) and carefully install the left half of the air
inlet housing to the right half of the housing.
2. Install the screws (4) that secure the two halves of the air inlet housing together. Tighten the screws to 2.2 Nm (20 in. lbs.).
NOTE: If the foam seal on the air distribution housing outlets is deformed or damaged, the seal must be replaced.
3. Inspect the foam seal (1), especially at the parting line (2). If the foam seal is deformed or damaged, it must be replaced.