PT Cruiser L4-2.4L Turbo (2009)
Driver/Vehicle Information Display: Removal and Replacement
Electronic Vehicle Information Center - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: LHD model shown in illustration. RHD model similar.
1. Disconnect and isolate the battery negative cable.
2. Remove the left and right A-pillar trimSee: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim
Panel-Removal.
3. Using a trim stick C-4755 or equivalent, disengage the snap retainers that secure the instrument panel top cover (1) to the top of the instrument
panel (2).
4. Remove the instrument panel top cover by gently pulling rearward on the cover to disengage the retainers from the front of the instrument panel.
5. Remove the screws (3) securing the Remote Compass Module (RCM) (2) to the instrument panel (1).
6. Disconnect the RCM electrical connector (5) and remove the RCM from the vehicle.
Electronic Vehicle Information Center - Installation
INSTALLATION