PT Cruiser L4-2.4L Turbo (2009)
Alarm Module: Service and Repair
Sentry Key Immobilizer Module (SKREEM) - Removal
REMOVAL
NOTE: The steering wheel does not have to be removed to service the SKREEM/WCM.
NOTE: The Steering Column Control Module (SCCM) assembly, which consists of the left/right multi-function switches and the clockspring,
does not have to be removed to service the SKREEM/WCM. After removing the right multi-function switch See: Sensors and
Switches/Sensors and Switches - Wiper and Washer Systems/Wiper Switch/Service and Repair/Right Multifunction Switch - Removal , there
is an access hole to access the SKREEM mounting screw (2).
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, personal injury or death.
2. Remove the upper and lower steering column shrouds See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service
and Repair/Steering Column Shroud - Removal and See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and
Repair/Steering Column Shroud - Removal.
3. Remove the right multi-function switch See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper Switch/Service and
Repair/Right Multifunction Switch - Removal.
4. Remove the SKREEM/WCM mounting screw (2) on the ignition lock assembly and separate the SKREEM/WCM (3) from the ignition lock
assembly.
5. Disconnect the SKREEM/WCM electrical connector (4).
6. Remove SKREEM/WCM (1 and 3) from column (2).