PT Cruiser L4-2.4L Turbo (2009)
CAUTION: Be certain not to tear the seat airbag nylon sleeve during removal.
Seat Air Bag - Installation
INSTALLATION
DEPLOYED SEAT AIRBAG
WARNING: Do not replace a deployed seat airbag. If the seat airbag has been deployed, the entire seat back and all damaged parts must be
replaced.
If the seat airbag was deployed, the entire seat back must be replaced See: Body and Frame/Seats/Seat Back/Service and Repair/Seat Back -
Installation/Front.
NONDEPLOYED SEAT AIRBAG
WARNING: Only replace a nondeployed seat airbag if faulty or defective.
NOTE: The seat airbag connector must face down (toward seat cushion) after installation.
1. Carefully slide the side airbag in nylon sleeve until mounting studs line up with holes provided in nylon sleeve. Be careful not to tear nylon sleeve
as this will affect function of airbag system.
CAUTION: The side airbag must be inside the nylon sleeve before installing retaining nuts. Failure to do so will adversely affect the function
of the side impact airbag system.
2. Pull seat airbag and nylon sleeve assembly up to line up mounting studs with holes provided in seat back frame mounting bracket. Install the seat
airbag retaining nuts. Tighten to 8.0 Nm (70.8 in. lbs.).