PT Cruiser L4-2.4L Turbo (2009)
5. Reach in under the cover and push down on the metal flap running the length of the top of the airbag housing.
6. Maneuver airbag cover out of the airbag housing.
Passenger Air Bag Cover - Installation
INSTALLATION
If reinstalling the airbag cover onto the same passenger airbag, perform the following adjustment. Otherwise, go to 1.
-
Using a 90° needle nose pliers or equivalent, place the pliers on the rear edge of the airbag cover metal flap retainer.
-
Bend roughly 10° so that the metal flap is closed slightly to eliminate rattles of the airbag cover.
-
Bend until the measurement of the metal flap to airbag housing is 7 - 8.3 mm (use a drill bit ranging from 9/32 - 21/64 inch).
1. Snap cover onto the passenger airbag frame.
2. Install the passenger airbag See: Passenger Air Bag - Installation.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
Driver Air Bag Cover - Removal
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
3. Remove the driver airbag See: Driver Air Bag - Removal.